Search results for "Micropower DC/DC"

About the Albright SD150A-2 Emergency Stop Switch Typically used on 12 volt and 24-volt dc systems as an emergency stop or kill switch. The SD150 has been designed to provide a rapid means of disconnecting batteries or other power supplies in the event of serious electrical faults. The operation of the switch is such that with the operating knob depressed i.e. in the “off” position, no electrical functions can take place. However, if the knob is in the “On” position, the option of energizing the coil and thus closing the main contacts becomes available. The coil energization can be carried out either through the vehicle key switch or as a result of a signal from the vehicle electronic controller. When used as an emergency battery disconnect switch, manually depressing the operating knob will override the energized coil such that the main contact and the auxiliary contact - where fitted) will open until such time as the knob is again moved to the “on” position. The SD150 combines the dual function of a manual disconnect and coil operated line contactor. The benefits of this design include compact size and reduced installation costs combined with an electrical capacity sufficient for small and medium-size electric vehicles. Whilst the switches are primarily intended for use with battery-powered vehicles, they are also suitable for use with static power systems. All types are capable of safely rupturing full load battery currents in the event of an emergency. Uninterrupted current - no or infrequent load switching requirements - maintains a lower contact resistance).

Read more less

About the DC88-1 Motor Reversing Solenoid Intermittent contactors by design are predominantly used for hydraulic functions on vehicles, they make and break quicker than continuous solenoids and are not recommended for prolonged contact periods. The main contact circuit, designed for motor reversing, has a built-in failsafe, so that if both coils are energised simultaneously the contact arrangement is open circuit. This version of the DC88 has M8 stud main terminals and 6.3mm spade coil connections. Mounting is via the integral bracket formed into the coil housing case. Mounting can be horizontal or vertical, when vertical the M8 contact studs should point upwards.

Read more less

Super duty contactor 1200A, 24V Continuous The SW1000 is designed for use in telecommunication and power distribution applications where an uninterrupted load is switched.  These contactors are primarily for use with Direct Current loads but can also be used with Alternating Currents. Type: SW1000-174Coil Voltage (V)                      24 CO DCCoil Resistance (Ohms)         19Pull In Voltage (V)                   16.0 MaximumDrop Out Voltage (V)              6.0 MaximumCoil Power Dissipation (W)     30.32

Read more less

JAQUET 820E-31141 Straight connector without cable, 3 pole DC

Read more less

About the ED125 Emergency Stop Switch  Typically used on 12 volt, 24 volt and 48 volt dc electric vehicle systems, the ED125 is a manually operated device with an over-centre spring mechanism, which provides a snap action for both opening and closing of the main contacts. The ED125 is easy to install - see drilling details) and is secured with supplied M5 Posidrive mounting screws.

Read more less

4000K Cold White Full Spectrum CRI97 Flexible LED light strip, with SMD2835 LEDs, 70LEDs/meter, 14,4W/meter. Supplied in 5 meters roll with white PCB and double adhesive tape for a better fixing. Can be cut every 10cm (7-LED segment). Requires 24V DC constant voltage LED driver. Complies with standard EN60598-1 and any other specific standards.

Read more less

SHARP 24/45 P6 Rev:01 Red/IEC/Rema160, PG: 2BB121L/1, Peters coating + silicon

Read more less